Home   |   About Us   |   PHONE: 513.272.0500   |   E-MAIL: SALES@POSITROL.COM    Request a Quote   
Outside Diameter
Gripping Chucks
Inside Diameter
Expanding Mandrels
Face Clamping
Chucks
Pitch Diameter
Clamping
Compensating
Chucks
Fixtures, Cartridge
Arbors / Chucks
Chuck
Change
Special
Applications
Chuck
Repair
New
Products
Case
Studies
513.272.0500
Positrol > Product Applications > Swing Clamp Chuck Decreases Scrap > View Items  
    Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Swing Clamp Chuck Decreases Scrap

Check up to five results to perform an action.





Increased Production: 250 pcs/shift
Scrap reduced: 715 pcs/month
Total Savings: $1700/ month

Part: Round Part 35 MM OD,  30 MM ID with a small flange.
Operation: Turn ID and face and hold the ID to 30.000 mm
Tolerances: ID size tolerance .021 mm, TIR runout of the flange over the OD of .05mm
Production Requirements: 13,000/Month
Part Issues: Part was slightly out ouf round before machining
Tried: Original method was to use a 3 Jaw chuck with pie jaws. Second attempt to use a quick change style collet chuck.

Recommendation: Spring Collet to locate and compensate for out of roundness to eliminate distortion.  Clamp on the face of the part for gripping force.